Top>Models Specifications>KIT-series>KIT160
- Not required for higher ridged roof building for beds of 2 M wide.
- The bolster is designed with Super Wide dimension on all sides.
- All assembling parts are meticulously inspected by 3-Dimension Measurement Machines (the length of the measured parts is 3 meters). Inspections have shown after assembly that the parallel, vertical and total clearance are well within JIS special grade.
- Load Split mechanism with 4 cranks and 4 plungers, crankshafts are aligned parallel respectively.
- To maintaining crankshaft stability, the latest machines are employed with high rigid mechanisms connecting to all slides with four-plungers which enable the load to be evenly distributed.
- The four-plungers (4-Points) slide mechanism prevents the crankshaft from deflection or bending, and prolong the life of precision dies.
- The coupling pins move in a front to back direction between the slide and the connecting rods.
- There is very little room for vibration of the slide longitudinally. No thrust vector is derived from the drive so that the dies will not be adversely affected.
KIT160
KIT160
| Press | KIT160 | |||||
| Capacity | kN | 1600 | ||||
| StrokeLength | mm | 100 | 150 | |||
| max.Strokes/ minutesmax |
SPM | 200 | 150 | |||
| Die height | mm | 400 | ||||
| SlideAdjustment | mm | 0 | ||||
| SlideArea | mm | 2000*600 | ||||
| Bolster | mm | 2000*700 | ||||
| Main Motor | kW | 30 | ||||
| 3D transfer feeder | - | KTES-100 | KTEⅡ-125L | KTES-200 | ||
| Feed stroke | mm | _100 | _125 | _200 | ||
| Clamping stroke | mm | _100 | _40 | _200 | ||
| Knockout stroke | mm | _30 | _30 | _60 | ||
| Weight | ton | 28 | ||||
| PaintColor (Body) | - | Japan Paint Manufactures Association A25-75B | ||||
| PaintColor (Slide) | - | Japan Paint Manufactures Association A22-50B | ||||
| Standard accesories |
Air clutch & brake |
| Jamming remover | |
| Automatic lubrication system | |
| Arrangement for stopping at a fixed point |
|
| Digital speed meter | |
| Digital angle indicator | |
| Control box with touch panel | |
| Production counter (8-digit) (Built-in display) |
|
| Preset counter (8-digit) (Built-in display) |
|
| Power outlets (100V/200 V one each) |
|
| Material end detecting switch (Proximity) |
|
| Connectors for-Mis grip (Sudden stop 12/24VDC) |
|
| Miss feed detection connector (Sudden stop1/24VDC) |
|
| Tension lock connector (Sudden stop1/24VDC) |
|
| Drip type punching oil supplier with 6-liter tank |
|
| Front safe door | |
| Air gun (1set) | |
| Cushion rubber pad |
| Optional | Lubrication heat & cool equipment |
| Air ejector | |
| Air power outlets | |
| Punching oil supplier (Electric pump) |
|
| Mist type punching oil supplier | |
| Material gild equipment | |
| Die area lighting | |
| Pat light(3-color) | |
| Material guide | |
| Chute for products | |
| Chute for scraps | |
| Connectors for-Mis grip (13ch and above) |
|
| Painting by designated color |
